PairMaster

The PairMaster gives its  user the ability to verify and test basic LAN cabling  installations. This unique LAN Cable tester can identify  one of up to 16 cables with the simply press of a  button. The PairMaster will also check for 8 faults including Near End Crosstalk (NEXT) for double split  pairs:

 Overvoltage
 Open Pair
 Shorted  Pair
 Crossed  Pair
 Split  Pair
 Reversed  Pair
  Transposed Pair
 Double  Split Pair

PairMaster, Includes: Remote Identifiers #1 and #2, (1) RJ-45  Patch Cable, (2) - RJ-45 In-Line couplers , (1) - 9 Volt  Battery, Instruction Manual.
Cat No. 3240

PairMaster  Kit, Includes: All 16 Remote Identifiers, (1)  RJ-45 Patch Cable, (2) - RJ-45 In-Line couplers , (1) - 9  Volt Battery, and Instruction Manual conveniently stored  in a hard-sided carrying case.
Cat No. 3241

Features

 EIA/TIA 568  configuration for UTP Ethernet and Token Ring LAN Cables
  Identifies 1 of 16 un-energized cables with the press of  a button
 Test 1/2,  3/6, 4/5, 7/8 Cable Pairs
 Detects 8  Faults including Near End Crosstalk (NEXT) for Double  Split pairs
 2-seven  segment LEDs display Fault Codes and Remote ID numbers
  Overvoltage Indication on PairMaster and Remote  Identifiers
 2 Year  Warranty on PairMaster
 1 Year  Warranty on Remote Identifiers
 Low  Battery Indication
 4 PASS  LEDs (Green)
 4 FAIL  LEDs (Red)

 

 Wire-MappingThe PairMaster will check the point to point wiring, commonly referred to as wire-mapping. This tells the user whether or not the cable pairs, 1/2, 3/6, 4/5, 7/8, are wired correctly at both ends. Green LEDs indicate Pass, Red LEDs indicate Fail. If a fault is detected, the corresponding Fault Code is displayed on the large, two digit, seven segment LEDs.

 Near End Crosstalk (NEXT) The Near End Crosstalk feature checks for excessive AC coupling between each pair in a cable. Once again, if a fault is detected, the PairMaster will display the Fault Code.

 Cable Identification The PairMaster can also identify a LAN Cable within a bundle. By connecting up to 16 available Remote Identifiers to the workstation wall jacks, the PairMaster will identify and display the number of the Remote Identifier connected to the cable. The user can then easily document the network topology.

 Overload Protection The PairMaster has built-in Overvoltage Protection. When voltage from a Central Office Battery is detected, the unit will flash (OL) and shut itself down.

 Remote Identifier The Remote Identifier is a small unit used in conjunction with the Triplett PairMaster for LAN Cable identification. The Remote Identifier properly terminates the LAN Cable when connected to the workstation wall jacks. It contains the necessary circuitry to allow the PairMaster to verify proper wiring within the cable. Each of the 16 Remote Identifiers has an overvoltaged LED which lights to indicate the presence of damaging voltage.

Specifications